  <chapter id="compiling">
    <title>Compiling the Wine Source</title>

    <para>
      In case you downloaded Wine source code files, this chapter will
      tell you how to compile it into binary files before installing them.
      Otherwise, please proceed directly to the <link
      linkend="installing">Installation chapter</link> to install the
      binary Wine files.
    </para>

    <sect1 id="compiling-wine">
      <title>Compiling Wine</title>

      <sect2>
        <title>Commands</title>
        <para>
	  To compile and install Wine, run the following commands:
	  <screen>
./configure
make depend
make
make install
	  </screen>
          Please note that the last command (<command>make install</command>)
          must be run as root.
        </para>
      </sect2>


      <sect2>
        <title>Requirements</title>
	<para>
	  For an up-to-date list of software requirements for compiling
	  Wine and instructions how to actually do it, please see the <ulink
	  url="http://www.winehq.org/source/README">README</ulink> file,
	  which is also available in the main directory of a Wine source
	  code tree.
	</para>
      </sect2>

      <sect2>
        <title>Space required</title>
	<para>
	  You also need about 400 MB of available disk space for compilation.
	  The compiled libwine.so binary takes around 5 MB of disk space,
	  which can be reduced to about 1 MB by stripping ('strip wine').
	  Stripping is not recommended, however, as you can't submit
	  proper crash reports with a stripped binary.
	</para>
      </sect2>
      
      <sect2>
        <title>Common problems</title>
	<para>
	  If you get a repeatable sig11 compiling shellord.c, thunk.c
	  or other files, try compiling just that file without optimization
	  (removing the -Ox option from the GCC command in the
	  corresponding Makefile).
	</para>
      </sect2>
    </sect1>
  </chapter>

<!-- Keep this comment at the end of the file
Local variables:
mode: sgml
sgml-parent-document:("wine-user.sgml" "set" "book" "part" "chapter" "")
End:
-->